Ttl Multiple Flash Photography - Nikon SB-24 Instruction Manual

TTL MULTIPLE FLASH PHOTOGRAPHY
As
the master flash unit, use Nikon Speedlight S8-24, S8-23,
S8-22, S8-218, S8-20, S8-18, S8-168 or S8-15 connected to an
F4, F-801/N8008, F-501/N2020, F-401s/N4004s, F-301/N2000,
FA, FE2 or FG camera, and for the slave flash unit(s), use the
S8-24, S8-22, S8-218, S8-20, S8-18, S8-17, S8-16A, S8-168
andlor
S8-15. Up to 5 flash units can be used.
For TTL multiple flash photography, connect the flash units via
the speedlight's TTL multiple flash terminal using optional TTL
Multi-Flash Sync Cord SC-18 (1 .5m)
andlor
SC-19 (3m).
Because S8-23, S8-22, S8-218, S8-20, S8-18 and S8-15 do not
have a TTL multiple flash terminal, it is necessary to use TTL
Remote Cord SC-17 or SC-24* when using these flash units as a
master flash unit. To use S8-22, S8-218, S8-20, S8-18
andlor
S8-15 as slave flash units, use TTL Multi-Flash Adapter AS-l0.
When using S8-140, S8-14
andlor
S8-11 for TTL multiple flash
photography, you should also use TTL Remote Cord SC-23.
* Used for F4 with DW-20 or DW-21 attached.
TTL auto flash is not possible when using Nikon F-401s/N4004s
with S8-11/14/140 (even with SC-23) or S8-218. These speed-
lights cannot be used for TTL multiple flash either, even as slave
flash units.
See system chart on the following pages.
• Set the power switch of slave flash units at ON position, not at
ST8Y. When using S8-24, S8-22 or S8-20
as a
slave unit with
the power switch at ST8Y position, lightly pressing the shutter
release button does not activate them. The same thing also
happens when you set S8-23 to TTL
(ST8Y);
do not use S8-23
as a
slave flash unit.
87