Nikon Speedlight SB-16 Instruction Manual page 10

-BASIC OPERATION-confinued----------
8
Attach the flash unit to
. the camera's accessory
shoe.
Notes:
1)
If
you are using an F3-series camera, make
sure that the ASAIISO film speed is already
set on the camera before attaching the flash
unit,
as
the camera's ASAIISO dial cannot
be changed after the flash is attached to the
accessory shoe.
2) For the Nikonos- V camera, an optional V- Type
Sync Cord is required. For details about flash
unit attachment to the Nikonos-V, refer to the
Sync Cord's instruction manual.
10
With the 5B·16A, turn the locking
ring
@
around the mounting foot
@
counterclockwise until the AS-8 's
foot is uncovered (fig. 1). Then slide
the mounting foot onto the camera 's
accessory shoe as far as it will go
(fig. 2). Finally, tighten the locking
ring to prevent the unit from acci -
dentally slipping off (fig . 3).
With the 5B·16B, turn the locking
nut
@)
on the mounting foot
®
coun-
terclockwise until it reaches its upper
limit (fig. 1). Then slide the mounting
foot forward into the shoe as far as it
wil l go (fig. 2). Finally, tighten the
locking nut to prevent the unit from
accidentally slipping off (fig. 3).