Table of Contents
Advertisement
Compulsory execution message
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is �nished.
Please do not unplug the power cable during the process.
Accumulative usage: 16HOURS
Proceed
• Panel Refresh
After cumulative usage over 500 hours,
Panel Refresh will run automatically
to adjust the uniformity of OLED to
prevent image retention caused by static
content. When it is activated, screen
will be in Standby mode for 30 seconds
to finish the process. Also, you cannot
skip Panel Refresh process but it could
be finished simultaneously while the
monitor goes into standby mode for
over 2 hours or while you turn off the
monitor.
Compulsory execution message
To reduce the risk of image retention, Panel Refresh will
automatically run after in use for a long periods of time.
Panel Refresh will take few seconds and power LED will blink
until it is �nished.
Please do not unplug the power cable during the process.
Proceed
• Auto Warning
Default setting is On to provide
messages as reminders of Pixel Refresh
and Panel Refresh automatically. You
can go to OSD menu > Setup > OLED
Panel Care > Auto Warning to turn off
Auto Warning messages. If you turn off
Auto Warning, the messages will not
appear, yet the calculation of cumulative
usage hours continues. If Auto Warning
is set to Off, the cumulative usage
exceeds 16 hours, Pixel Refresh will be
activated automatically when you press
the power button or the monitor goes
into Standby mode.
A reminder message that pops up after 4 hours of
continuous use, and will then appear every 2 hours
after.
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is �nished.
Please do not unplug the power cable during the process.
Accumulative usage: 4HOURS
Do you want to activate Pixel Refresh now?
Note
1. Pixel Refresh and Panel Refresh
can be run whenever you detect a
luminance gap or image sticking.
2. When the monitor is in standby
mode for over two hours, Refresh
will recognize this and run
automatically. Also, if the user
turns off the monitor, Refresh will
run automatically. This ensures
your display has the best possible
performance while minimizing the
amount of interruptions.
LED Indicator
Status
Power On
Standby
Pixel Refresh
Panel Refresh
Panel Error
Power Off
24
Yes
No
LED Color
White
White (breathing)
White (blinking)
Amber (blinking)
Amber
No LED
Advertisement
Table of Contents
