Table of Contents
Advertisement
7.2
Power Supply
Refer to figure
Figure 7-2
platform.
CN8601(FOR 715G7720/715G7831)
Display power
PFC(except 32")
7.2.1
Power Supply Unit
All power supplies are a black box for Service. When defective,
a new board must be ordered and the defective one must be
returned, unless the main fuse of the board is broken. Always
replace a defective fuse with one with the correct
specifications! This part is available in the regular market.
Consult the Philips Service web portal for the order codes of the
boards.
Important delta's with the TPM16.2HE LA classis platform are:
•
New power architecture for LED backlight
•
"Boost"-signal is now a PWM-signal + continuous variable.
The control signals are:
•
Stand-by
•
Lamp "on/off"
•
DIM (PWM) (not for PSDL)
In this manual, no detailed information is available because of
design protection issues.
The output voltages to the chassis are:
•
+8.5V output (standby mode)
•
+12 output (on-mode)
•
+12V_audio (audio AMP power)
•
+70.4V LED Input Voltage for 49''
•
+72V LED Input Voltage for 55''/65''
for the power architecture of this
Ac-input + Mains filter
Figure 7-2 Power Architecture
Connector
Number
CN9101
CN8602
Description
to SSB
to panel
Pin
14
8
1
DIM
VLED+
2
On/off
VLED+
Circuit Descriptions
Platform power
BL-ON/OFF
DIM
PS_On
12V
12V_A
Low stby
power
AC IN
CN9901
•
Output to the display; in case of
- IPB: High voltage to the LCD panel
- PSL and PSLS (LED-driver outputs)
- PSDL (high frequent) AC-current.
7.2.2
Diversity
The diversity in power supply units is mainly determined by the
diversity in displays.
The following displays can be distinguished:
•
CCFL/EEFL backlight: power panel is conventional IPB
•
LED backlight:
- side-view LED without scanning: PSL power panel
- side-view LED with scanning: PSLS power panel
- direct-view LED without 2D-dimming: PSL power panel
- direct-view LED with 2D-dimming: PSDL power panel.
PSL stands for Power Supply with integrated LED-drivers.
PSLS stands for a Power Supply with integrated LED-drivers
with added Scanning functionality (added microcontroller).
PSDL stands for a Power Supply for Direct-view LED backlight
with 2D-dimming.
7.2.3
Connector overview
Table 7-1 Connector overview
CN9101
CN8603
to SSB
to panel
16
12
DIM
VLED+
BL_ON/OFF
n.c.
back to
div.table
TPM16.2HE LA
AMP
12V
Platform
MT5593U+NT72324
CN1190
1 power- PCB
CN9101
CN8603
to SSB
to panel
16
12
DIM
VLED+
BL_ON/OFF
n.c.
7.
EN 29
LVDS AMP
12V
20130_201.eps
2016-May-27
Advertisement
Table of Contents
