Nikon COOLPIX P310 Reference Manual page 229

Problem
Reset file Reset file numbering cannot be applied when the folder
numbering number reaches 999 and there are images in the folder. Change
cannot be done. the memory card, or format the internal memory/memory card.
Monitor is turned Battery temperature is high. Turn off camera, and allow battery to
off, and the power- cool down before resuming use. After the lamp flashes for three
on lamp flashes minutes, the camera turns off automatically, but you can also
quickly. press the power switch to turn it off manually.
When functions such as movie recording or sending images
Camera using an Eye-Fi card are used for a long time, or when the camera
temperature rises. is used in a location with a high ambient temperature, the
camera temperature may rise. This is not a malfunction.
b Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear on the monitor and
the camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. Note that disconnecting the power source as
described above may result in the loss of any data not recorded on the internal
memory or memory card at the time the problem occurred. Data already recorded
is not affected. In the event of continued malfunction, contact your retailer or
Nikon-authorized service representative.
Shooting Issues
Problem
Cannot set to
Disconnect the HDMI cable or USB cable.
shooting mode.
• When camera is in playback mode, press the c button,
• When menus are displayed, press the d button.
No picture can be
• Battery is exhausted.
taken.
• When the scene mode is Night portrait or Backlighting
• When flash lamp flashes, flash is charging.
In some shooting conditions, such as when the subject moves or
Cannot take 3D
the subject is dark or low in contrast, the second shot may not be
pictures
taken or the 3D picture may not be saved.
Cause/Solution
Cause/Solution
shutter-release button or b (e movie-record) button.
with HDR set to Off, raise the flash.
Troubleshooting
A
100,
E86
21
93
A
86, 89,
E24,
E27
30
11
20
41, 45,
60
60
–
F9