Jump-Starting - Yamaha WOLVERINE R MAX 2021 Manual

the battery, the main switch must be
off, and the positive lead must be con-
nected before the negative lead.
1
1. Positive battery lead (red)
2. Negative battery lead (black)
3. Install the battery holding plate by install-
ing the bolts.
4. Install the hood.
TIP
 Make sure the battery leads are installed as
shown.
 Fully charge the battery before installing it.
EBU32651

Jump-starting

Jump-starting the vehicle should be avoided.
[ECB01111]
The battery should be removed and charged
instead.
However, if the vehicle must be jump-started,
proceed as follows.
EWB03430
WARNING
To avoid battery explosion and/or serious
damage to the electrical system:
2
 Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.
 Do not touch the positive lead of the
jumper cable to the negative lead.
 Do not reverse the polarity of the jumper
cables when connecting to the batteries.
1. Turn the key to "
2. Remove the hood. (See page 9-10.)
3. Using a charged 12-volt battery, connect
the positive lead of the jumper cable to
the positive terminal of the battery in the
9-52
" (off).
9