Nikon COOLPIX S630 User Manual page 165

Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact your
retailer or Nikon-authorized service representative. Note that disconnecting the
power source as described above may result in the loss of any data not recorded to
internal memory or the memory card at the time the problem occurred. Data
already recorded will not be affected.
Shooting
Problem
No picture taken when
shutter-release button
is pressed.
Camera cannot focus.
Pictures are blurred.
Bright specks appear in
pictures shot using
flash.
Flash does not fire.
Optical zoom cannot be
used.
Cause/Solution
• When camera is in playback mode, press the A button.
• When menus are displayed, press the d button.
• Battery is exhausted.
• When flash lamp blinks red, flash is charging.
• The intended subject is one with which autofocus does
not perform well.
• Set AF assist in the setup menu to Auto.
• Turn camera off and then on again.
• Use flash.
• Use high sensitivity mode to take pictures.
• Use vibration reduction and motion detection.
• Use D (Best Shot Selector).
• Use a tripod to stabilize the camera (use with the self-
timer for best results).
Flash is reflecting off particles in air. Turn flash W (off ).
• Flash is W (off ).
• Some scene modes that cannot turn on flash are selected.
• Sport continuous mode is selected.
• The Blink proof setting is set to On for smile mode.
• D mode is selected.
• Continuous, BSS, or Multi-shot 16 is selected for
Continuous in shooting menu.
Optical zoom cannot be used while recording movies.
Troubleshooting
A
8, 28
12
22
31
27
133
17
30
50
131, 132
105
32
31
30
35
48
53
77
105
77
153