NEC MDview 193 User Manual page 14

RESOLUTION NOTIFIER
This optimal resolution depends on the MDview model's native resolution. If ON is selected, a message will appear
on the screen after 30 seconds, notifying you that the resolution is not at the respective MDview model's native
resolution - 1280 x 1024 or 1600 x 1200 or 1920 x 1200.
HOT KEY
You can adjust the brightness and contrast directly. When this function is set to ON, you can adjust the brightness
with "Left" or "Right", contrast with "Down" or "Up" buttons, while the OSD menu is off. The standard OSD can be
accessed with the EXIT button.
FACTORY PRESET
Selecting Factory Preset allows you to reset all OSD control settings (BRIGHTNESS, CONTRAST, ECOMODE,
AUTO BRIGHTNESS, BLACK LEVEL, IMAGE CONTROL, COLOR CONTROL SYSTEM, SHARPNESS, OFF
TIMER, IPM, OSD LEFT/RIGHT, OSD UP/DOWN, OSD TURN OFF, OSD TRANSPARENCY) back to the factory
settings. Individual settings can be reset by highlighting the control to be reset and pressing the RESET button.
Information
Provides information about the current resolution display and technical data including the preset timing being used
and the horizontal and vertical frequencies. Indicates the model and serial numbers of your monitor.
OSD Warning
OSD Warning menus disappear with Exit button.
NO SIGNAL: This function gives a warning when there is no Horizontal or Vertical Sync. After power is
turned on or when there is a change of input signal, the No Signal window will appear.
RESOLUTION NOTIFIER: This function gives a warning of use with optimized resolution. After power is
turned on or when there is a change of input signal or the video signal doesn't have proper resolution, the
Resolution Notifier window will open. This function can be disabled in the TOOL menu.
OUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. After
the power is turned on or there is a change of input signal or the video signal doesn't have proper timing,
the Out Of Range menu will appear.
NOTE: It is possible to change the DVI SELECTION or to change the IPM settings while the "NO SIGNAL"
NEC MDview 242/242-2 and 262/262-2 Only!
PORTRAIT WARNING: When the monitor is used in portrait position, the brightness value will be reduced
to 300 cd/m
appear on the screen for 10 seconds.
LUMINANCE WARNING: When the backlight cannot display the desired luminance, a message will
appear on the display. To avoid this, reduce the BRIGHTNESS level or set the AUTO LUMINANCE function
to OFF (page 22, TAG1).
For advanced user menu see "Appendix".
or "OUT OF RANGE" messages are displayed.
2 (MDview 242-2 and MDview 262-2 = 250 cd/m 2 ). If the Portrait Warning is ON, a message will
English-12