Electrolux EUN12510 User Manual page 10

10 electrolux
1. Connect the wire coloured green and
yellow to the terminal marked either with
the letter "E" or by the earth symbol
or coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
"N" or coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or
coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
secure over the outer sheath.
5. Make sure the electricity supply voltage
is the same as that indicated on the ap-
pliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp
2
plug fitted . In the event of having to
change the fuse in the plug supplied, a 13
amp ASTA approved (BS 1362) fuse must
be used.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
Door reversibility
The door of the appliance opens to the
right. If you want to open the door to the
left, follow these steps before you install the
appliance:
1. Loosen and remove the upper pin.
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
On the opposite side:
1. Tighten the lower pin.
2. Install the spacer.
3. Install the door.
4. Tighten the upper pin.
4
is
Ventilation requirements
The airflow behind the appliance must be
sufficient.
Installing the appliance
Caution! Make sure that the mains
cable can move freely.
Do the following steps:
min.
200 cm
2
min.
200 cm
2