Ipv4 Static Routing Configuration; Using The Gui - TP-Link T1600G-52TS User Manual

Configuring Routing
2

IPv4 Static Routing Configuration

2.1

Using the GUI

Choose the menu L3 FEATURES > Static Routing > IPv4 Static Routing and click
to load the following page.
Figure 2-1 Configuring the IPv4 Static Routing
Configure the corresponding parameters to add an IPv4 static routing entry. Then click
Create.
Destination
Subnet Mask
Next Hop
Distance
Specify the destination IPv4 address of the packets.
Specify the subnet mask of the destination IPv4 address.
Specify the IPv4 gateway address to which the packet should be sent next.
Specify the administrative distance, which is the trust rating of a routing entry. A
higher value means a lower trust rating. Among the routes to the same destination,
the route with the lowest distance value will be recorded in the IPv4 routing table.
The valid value ranges from 1 to 255 and the default value is 1.
IPv4 Static Routing Configuration
User Guide 418