Table of Contents
Advertisement
20
www.aeg.com
If you press detergent
tank button while Stains
option is active,
AutoDose function is
switched off, but Stains
option still remains active
in manual mode.
•
Prewash
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust, mud and other
solid particles.
When selecting a pre-
wash phase and
AutoDose is active, the
appliance will
automatically dose the
detergent. When
AutoDose is switched off,
put the detergent/additive
in a dosing ball inside the
drum.
The options can increase the
programme duration.
7.13 Spin
When you set a programme, the
appliance automatically selects the
default spin speed.
Touch this button repeatedly to:
• Change the spin speed.
The display shows only
the spin speeds available
for the set programme.
• Activate the Rinse Hold option .
The water of the last rinse is not
drained out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum and the
final spin phase is not performed.
The display shows the indicator
The drum turns regularly to reduce
creasing.
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch Start / Pause button
appliance performs the spinning
phase and drains the water.
• Activate the Extra silent option.
All spinning phases (intermediate spin
and final spin) are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
The display shows the indicator
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch the Start / Pause button: the
appliance performs only the draining
phase.
• No Spin
Set this option to deactivate all spin
phases. The display shows the
indicator
performs the only draining phase of
the selected washing programme. Set
this option for very delicate fabrics.
The rinses phase uses more water for
some washing programmes
The appliance empties the
water out automatically after
approximately 18 hours.
7.14 Temperature
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
.
and
, the appliance does not heat
the water.
: the
.
.
. The appliance
Advertisement
Table of Contents
