Table of Contents
Advertisement
Procedure
To power on the system, complete the following steps.
1. Wait for all expansion enclosures to finish powering on.
2. Power on the control enclosure. Use the supplied power cords to connect both power supply units of
the enclosure to their power sources.
If the power sources have circuit breakers or switches, ensure that they are turned on. The enclosure
does not have power switches.
Notes:
• Each enclosure has two power supply units. To provide power failure redundancy, connect the two
power cords to separate power circuits.
• Ensure that each power cable is secured to each PSU on the back of the enclosure.
What to do next
Next, you will connect an Ethernet cable to the technician port on the control enclosure, and initialize the
system.
62 FlashSystem 5100 : Quick Installation Guide for MTM 2078-4F4, 2078-4H4, 2078-12G, 2078-AFG,
2078-24G, 2078-A9G, 2078-92G, and 2078-UHB
Advertisement
Table of Contents
