Intended Use; Important Safety Instructions - Black & Decker BEPW1600LLP Manual

ENGLISH
Maximum Input Pressure
Repulsive Force of the Gun
to the Maximum Pressure
Motor Protection
Inlet Water
Voltage
Frequency
Power
Rated Flow Rate
Max Water Flow Rate
Rated Pressure
Maximum Pressure
Maximum Inlet Temperature
Maximum Input Pressure
Repulsive Force of the Gun
to the Maximum Pressure
Motor Protection
Inlet Water

Intended use

This pressure washer is intended for household use for
cleaning boats, cars, decks, driveways, grills, house siding,
motorcycles, patios, and outdoor furniture.
Do not let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Safety instructions

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using this pressure washer,
basic safety precautions should always be
followed including the following:
Š If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Š This machine is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge.
Š Children should be supervised to ensure that they do not
play with the appliance.
Š Read all the instructions before using the product.
8
(Original instructions)
Bar 10
N 21
IPX5
Cold clear
Water
BEPW2200
V 220-240
AC
Hz 50/60
W 2000
L/min 5.8
L/min 7.5
Bar /PSI 105/ 1523
Bar/PSI 150/2175
˚C 50
Bar 10
N 21
IPX5
Cold clear
Water
Š To reduce the risk of injury, close supervision is necessary
when a product is used near children.
Š Know how to stop the product and bleed pressures
quickly. Be thoroughly familiar with the controls.
Š Stay alert – watch what you are doing.
Š Do not operate the product when fatigued or under the
influence of alcohol or drugs.
Š Keep operating area clear of all persons and animals.
Š Do not overreach or stand on unstable support. Keep
good footing and balance at all times.
Š Follow the maintenance instructions specified in
the manual.
Š The electric supply connection shall be made by a
qualified electrician and comply with IEC 60364-1. It is
recommended that the electric supply to this machine
should include either a residual current device that will
interrupt the supply if the leakage current to earth exceeds
30 mA for 30 ms or a device that will prove the earth
circuit.
WARNING: Risk of injection or injury – do not
direct discharge stream at persons or animals.
WARNING: Read this entire manual before
attempting to assemble, operate or install the
product.
WARNING: This unit was designed for specific
applications. It should not be modified and/or used for
any application other than that which it was designed.
NOTICE: Always store your pressure washer in a
location where the temperature will not fall below
40 °F (4 °C). freeze damage is not covered by
the warranty.
1 . Do not touch plug or outlet with wet hands.
2 . Avoid accidental starts. Move switch on unit to OFF
position before connecting or disconnecting cord
to electrical outlets.
3 . Water spray must never be directed towards any
electric wiring or directly towards the pressure
washer machine itself or fatal electric shock
may occur.
4 . Never carry your pressure washer by the cord. Do not
pull on the cord to disconnect from the outlet.
5 . To prevent damage, the cord should not be
crushed, placed next to sharp objects or near a
heat source.
6 . Check power cords before using. Damaged cords can
reduce performance of pressure washer or cause a
fatal electrical shock
7 . The narrow pin point stream is very powerful. It is
not recommended for use on painted surfaces,
wood surfaces or items attached with an
adhesive backing.