Downflex 200-M (Only - Lincoln Electric K2751-2 Operator's Manual

B-5

DOWNFLEX 200-M (Only)

CONTROL PANEL
The control panel is equipped with the following con-
trols. (See Figure B.2):
A. Main Switch
B. Magnehelic Gauge
C. ON Button
D. OFF Button
FIGURE B.2 – CONTROL PANEL
B
PLASMA CUTTING:
548602
– standard work grid: NO plasma cutting
– plasma cutting work grid: max. 50 A
OTHER APPLICATIONS:
– READ THE MANUAL
A
OPERATION
1. Turn on the main switch (A). See Figure B.2.
2. Push the ON button (C) to switch on the fan. See
Figure B.2.
3. Start welding/grinding.
4. After finishing welding/grinding, push the OFF but-
ton (D) to switch off the fan. See Figure B.2.
5. Turn switch (A) off to remove the main input power.
OPERATION
ON
C
OFF
D
DOWNFLEX 200/400
FILTER REPLACEMENT
1. During use, regularly check the Magnehelic gauge
(B). When the pressure reaches 0.25 psi (1700
Pa), the filter cartridges need to be replaced. See
Figure B.2.
2. Refer to Filter Replacement for the filter replace-
ment procedure.
B-5