Electrical Connection - Lincoln Electric K2751-2 Operator's Manual

A-9
CAUTION
Do not position the product where it is exposed
to vibrations or heat radiation from heat sources.
Observe the earlier described ambient conditions.
------------------------------------------------------------------------
FIGURE A.14 – CARGO LASHINGS
• Position the downdraft table against the wall.
• If necessary, use the adjusting feet to level the
downdraft table and to adjust it to the desired height
(min. 36 in. - max. 38 in. 920-970 mm). See Figure
A.15.
FIGURE A.15 – ADJUSTABLE FEET
50 mm
INSTALLATION

ELECTRICAL CONNECTION

Make sure that the system is suitable for connec-
tion to the local input power. Information about
the connection voltage and frequency can be
found on the identification plate.
The input power must be connected in confor-
mance with the local codes and regulations and
can only be installed by well qualified and autho-
rized technicians.
------------------------------------------------------------------------
If necessary: change motor from 480V to 208/240V
Default setting of the motor is 480V. Depending on the
local input power voltage, the setting could be
changed to 208/240V. This concerns both the motor
and the transformer.
------------------------------------------------------------------------
DOWNFLEX 200/400
WARNING
CAUTION
WARNING
Make sure the downdraft table is
disconnected from input power.
A-9