3M PELTOR WS LiteCom Pro III Fitting Instructions Manual page 3

Helmet Attach Headset
To fit the hearing protector:
• Fit the cup: Push the attachment blade firmly into the slot
on the side of the helmet until it clicks into place (Fig 1 & 2)
• Working position: With the cups over the ears press the
arms inwards until you hear a click on both sides indicating
a firm seal (Fig 3).
• Stand-by position: Lift the cups to the fixed stand-by
position. In a noisy environment the ear muffs must be
worn in the working position at all times (Fig 4).
• Parking position: First lift the cups to the stand-by position
(Fig 4), then rotate them up to the next fixed position.
• Ventilation mode: Avoid placing the cups against the
helmet as this prevents ventilation (Fig 5).
• Storage mode: When the helmet is not in use, lower the
earmuffs and press them inward. Keep the cups clean and
dry and store at normal room temperature.
1 2
4
Fit Check
When hearing protectors are correctly worn, your voice
should sound hollow and sounds around you should not
sound as loud as before.
Hearing Protector Fit Testing the 3M
E-A-Rfit Dual-Ear Validation System
™
The success of your hearing conservation program requires
more than offering earplugs or earmuffs. Each worker
needs to wear the most effective hearing protector for the
environment and the correct fit for their unique anatomy.
With 3M E-A-Rfit Dual-Ear Validation System, you can
™ ™
quickly identify how much protection each worker receives
from their 3M hearing protectors.
3
5
™
The Technology Behind 3M
The 3M E-A-Rfit Dual-Ear Validation System is based on
™ ™
Field Microphone-In-Real Ear (F-MIRE) technology that
measures the effectiveness of hearing protectors from inside
a worker's ears, providing accurate, quantitative results.
The tester wears a pair of modified 3M
protectors connected to a dual-element microphone. A
loudspeaker is placed in front of the tester. When it emits a
broadband noise, the dual-element microphone measures the
signal in the ear canal and outside the ear plug. In less than
five seconds, the difference between the two measurements
is calculated and a Personal Attenuation Rating (PAR) is
displayed.
It Starts with PAR
The 3M E-A-Rfit Validation System puts the worker in the
™ ™
context of their noise environment and helps you understand
their level of attenuation.
The results you get from the 3M
PAR. The PAR is a numerical value that shows the reduction in
sound level within the ear when a hearing protector is worn.
The resulting PAR, combined with the worker's exposure
to noise, is used to determine if a worker is receiving
appropriate protection from the noise hazard.
Knowing the PAR lets you identify workers who are
inadequately protected, so you can provide real-time
intervention and training.
Key Benefits of the 3M
Dual-Ear Validation System include:
• Tests both ears simultaneously in less than 5 seconds
• Science-based, quantitative testing
• Fast, clear, and accurate results
• Tests 7 frequencies 125Hz to 8000Hz
• 3M Earplug, earmuff and headset (comms) testing
™
capability
Contact your 3M Personal Safety Specialist to find out more
about our 3M E-A-Rfit Dual-Ear Validation System or for
™ ™
assistance in solving your complex or day-to-day hearing
conservation challenges
E-A-Rfit
™ ™
probed hearing
™
E-A-Rfit is displayed as a
™ ™
E-A-Rfit
™ ™