Table of Contents
Advertisement
Display
The indicator lamp of
the Drum Clean pro-
gramme flashes
Other displays
Faults and what to do about them
Faults
Water is leaking from the
appliance.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
The wrong detergent/fab-
ric softener has been
poured into the dis-
penser(s).
Detergent/fabric softener
has congealed in the dis-
pensers.
The door cannot be
opened.
Cause/Remedy
Run the Drum Clean 90°C programme to clean and care for the drum and the
outer tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the Drum Clean information signal on/off.
■
~ "Switching the drum-care information signal on/off" on page 40
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer service.
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
Programme does not start?
■
Is the water tap turned on?
■
Could the filter in the water supply be blocked?
■
~ "Filter in the water supply is blocked" on page 44
Is the supply hose kinked or trapped?
■
Dispenser(s):
Empty and clean.
1.
2.
Refill.
Clean and refill the dispensers.
Childproof lock activated? Deactivate childproof lock.
■
The temperature in drum is too high to open the door.
■
The safety function is activated. Stop the programme?
■
The water level in drum is too high.
■
Can the door only be opened by the emergency release?
■
~ "Emergency release" on page 45
Faults and what to do about them
en
47
Advertisement
Table of Contents
