Table of Contents
Advertisement
Figure 81
1. Cover
7.
Position the seat.
g012434
2. Bolt
Brake Maintenance
Adjusting the Parking
Brake
Service Interval: After the first 100 hours
Every 500 hours thereafter
Note:
Follow this procedure also after removing or
replacing a brake component.
1.
Drive the machine onto a level surface.
2.
Disengage the blade-control switch (PTO), move
the motion control levers to the N
position, and engage the parking brake.
3.
Shut off the engine, wait for all moving parts to
stop, and remove the key.
4.
Raise the back of the machine and support the
machine with jack stands.
DANGER
Mechanical or hydraulic jacks may fail
to support machine and cause a serious
injury.
• Use jack stands when supporting
machine.
• Do not use hydraulic jacks.
5.
Remove the rear tires from the machine.
6.
Remove any debris from the brake area.
7.
Rotate the drive-wheel release handle to
the released position; refer to
Drive-Wheel-Release Valves (page
8.
Check to see if there is a visible gap between
the L-bracket and the linkage stop
57
-
EUTRAL
LOCK
Using the
33).
(Figure
82).
Advertisement
Table of Contents
