Cleaning The Inside Of The Sprocket Guard; Cleaning The Guide Bar - Dolmar PS-350 C Instruction Manual

Cleaning the inside of the sprocket guard

CAUTION: Before doing any work on the guide bar or chain,
always switch off the engine and pull the plug cap off the
spark plug (see „Replacing the spark plug"). Always wear
protective gloves!
CAUTION: Start the chain saw only after having assembled
it completely and inspected.
4
Remove the sprocket guard (1) (see PUTTING INTO OPERA-
TION for the correct model) and clean out the interior with a
brush.
Remove the chain (2) and guide bar (3).
NOTE:
3 2
Make sure there are no residues or foreign matter remaining in
the oil guide groove (4) or on the chain tensioner (5).
To install the guide bar, saw chain, and sprocket guard, see
5
PUTTING INTO OPERATION for the correct model.
NOTE:
The chain brake is a very important safety device and like
1
any other component subject to normal wear and tear.
Regular inspection and maintenance are important for
your own safety and must be done by a DOLMAR service
centre.
SERVICE

Cleaning the guide bar

CAUTION: Protective gloves must be worn.
Regularly inspect the bearing surfaces of the guide bar (7) for
damage, and clean them with a suitable tool.
Keep the two oiling holes (6) and the entire guide bar clean and
free of foreign matter!
6 7
27