Advertisement
1
Step 1
6" - 200mm
Behind
wall stud
Step 1
Step 1: Make sure the water supply (hot/cold) line is
6 inches (200mm) apart from the center of the Hot &
Cold water supply pipes.
There should be a distance of 7.9 inches (250mm)
between the two wall studs.
Step 2: Screw in the connectors on the short end, to
the water supply pipes.
4
Installation Instructions
BEFORE YOU BEGIN
Measure the following to ensure
your tub filler will fit properly.
Step 1
7.9" - 250mm
6" - 200mm
Step 1
2
Nut
surface
The surface of the nut should be flush with the
concrete wall.
2
Step 3
Step 2
Step 1: Use a level to confimr correct placement of
the mount. Mark the drill hole marks with a pencil.
Step 2: Drill in the screws to place mounting plate on
the wall stud.
Step 3: Tighten the two connectors with nuts on the
mounting plate.
Nut
surface
Step 1
Advertisement
