Using The Tuner - Tascam CD-BT1 Owner's Manual

Using the tuner

e s builtin tuner has two
modes an automatic mode where
the pitch of the incoming signal is
detected and displayed automatically
and a manual mode where you set the
target and tune to it
ress the MENU key until the display
shows and then press
TUNER,
hen you enter the tuner mode any
effect is automatically turned off
f the tuner is in automatic mode
shown as on the display just play
AT
a note on your bass e tuner guesses
the closest note and shows it on the
display
e symbols to the left and right of
the larger center symbol show that the
incoming note is either flat shown by
a on the display or sharp 
â
tively
18
— TASCAM CD-BT1
une the string roughly so that the
right note appears and then adjust the
tuning until the tuning display shows
only a large center blob with both
the and
õ Ã
e range of the tuner is between 
and  which covers almost all the
 useful audible range
ENTER
f the tuner is in manual mode shown
as on the display use the
MT
keys to set the note on the display and
then tune as above
Calibrating the tuner
sually the  above iddle  is tuned
to z in most estern music
ere may be times when you need to
tune to a different standard you are
playing with another instrument or to
a  which does not use the z
tuning se the tuners
menu to set the reference  to a tun
ing between z and z
 respec
Ã
showing
and fl
6
calibration
CAL
NOTE
Although you do not need to play a CD when
you are tuning, the CD-BT1 must be switched
on, and the BASS button must be pressed in
to allow tuning of the instrument plugged
into the CD-BT1.