Using The Cd Player - Tascam CD-BT1 Owner's Manual

Using the CD player

e s  player works
in much the same way as other 
players with a few minor differences
and special features as explained on
this page
oad s label side up shiny side
down in the  pen and
close the player door by hand by lifting
the door tab marked PULL
NOTE
The CD-BT1 cannot play unfinalized CD-R/
RW discs. In addition, some finalized CD-R/
RW discs may be unplayable on the CD-BT1.
Playback
ress the playpause 
Á/π
start playback and to pause playback
ress the stop key   to stop play
ª
back
Display
se the key to change
DISPLAY/ESC
the display between track elapsed
time track remaining time and total
remaining time you cannot do this in
menu mode
12
— TASCAM CD-BT1
Skipping between tracks
se the two skipsearch keys marked
as
Ô?Â
back and forward a track at a time by
pressing and releasing the appropriate
key
Searching within tracks
se the skipsearch keys to search

within the disc by pressing and hold
ing the appropriate key
The CUE key
e CUE key is a special feature of the
 hen you press this key the
playback position returns to the last
 key to
point where playback started
hat happens next depends on the
menu item setting in the
f this is set to
at the cue point but if it is set to
playback restarts from the cue point
TIP
With a footswitch connected, you can use
this instead of the
operation (set the FOOT menu item to CUE).
and  to move
¯?
CUE
menu
MENU
 playback is paused
CUE

FLS
CUE
key for hands-free
Looping (track)
sing the menu item set
PLAY
gle play ress the LOOP
you see on the display bottom
LOOP 1
left e current track will repeat
Looping (disc)
sing the menu item set
PLAY
all the disc ress the LOOP
that you see alone on the display
LOOP
bottom left e whole disc will
repeat
Looping (I/O points)
se the I/O key to set the start in
point of the loop then use the key to
set the end out point e section be
tween the points will repeat seamlessly
ressing the I/O key again clears the
loop points and cancels loop mode
ith these points set  shown on the
I-O
display you can restart the  loop
mode if it has been canceled using the
LOOP key
sin
SGL
key so that
play
ALL
key so