Table of Contents
Advertisement
Targus ExpressCard Notebook Docking Station with Digital Video and Audio
About the ExpressCard
Connector Card
The ExpressCard dock comes with a cable, a spacer (see "Using
the Spacer Connector" for additional instructions) and a 34mm
card to connect to an ExpressCard slot in your notebook. The
cable is removable from the card. The card can be left in your
notebook when not in use.
The 34mm card has a small switch highlighted in the circular area
of the below diagram.
On-Pre-boot support
Off-Post-boot support (Default)
This switch is used to determine how the dock is recognized by the
computer during boot up. Certain notebooks will detect the dock
and will not work properly during the pre-boot mode (i.e. trying to
boot up on the external VGA device, rather than the internal VGA of
the notebook). This was observed in some notebooks (e.g. Fujitsu,
and some Sony and Toshiba models) that use a BIOS developed
by Phoenix Technologies. If you experience such an issue, please
turn the switch from the default "OFF" position to "ON". You will only
need to set it once.
Advertisement
Table of Contents
