Advertisement
STEP 3:
(SEE FIGURE 4)
•
Place plug (D) on a work bench or solid table and
push end of bumper down onto plug. Repeat for all
four plugs.
STEP 4:
(SEE FIGURE 5)
•
Attach ]eft mounting bracket to hole shown in ]eft side
of tractor frame using a carriage bolt (A) and whizlock
nut (C). Align middle hole in bracket with empty hole
in tractor frame. Tighten whizlock nut (C) only enough
to keep bracket in alignment until step 5. Repeat for
right mounting bracket.
STEP 5:
(SEE FIGURE 6)
•
Fasten bumper to mounting bracket using a hex bolt
(B), pivot spacer (E), a locking lever and a whizlock
nut (C) as shown. The pivot spacer inserts into hole in
bumper. Tighten both nuts on mounting bracket at
this time. Repeat for other side.
•
Assemble plastic grips (F) onto locking levers.
•
Lift up on bumper until pins in locking levers snap into
holes in mounting brackets.
IMPORTANT: You must lower bumper before raising tractor
hood. Pull out on locking levers and push bumper down as
far as it will go.
BUMPER
PUSH DOWN
WITH EVEN
PRESSURE
WORK BENCH
OR SOLID TABL__
(GT) FRAME
SHOWN
CARRIAGE
LEFT MOUNTING
BUMPER STOPS
BOLT (A)
BRACKET
FACE OUT
..........
WHIZLOCK
NUT (C)
I
AUGN TRESE
ROLES
LEFT SIDE VIEW
FIGURE 5
HEX BOLT (B)
WHIZLOCK_-
(C)
PIVOT
SPACER (E)_
STEP 6:
(SEE FIGURE 7)
•
Replace the front screws and browning shield you
removed in Step 2 as shown.
LEVER
FIGURE
6
GRIP (F)
LEFT SIDE VIEW
REPLACE
FRONT
SCREWS
REPLACE
BROWNING
SHIELD
FIGURE 7
LEFT SIDE VIEW
4
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
