Table of Contents
Advertisement
Energy consumption indicator
en
[Energy consumption
indicator
T his function indicates the total amount of energy
E n e r g y c o n s u m p t i o n i n d i c a t o r
consumed by this hob the last time it was used for
cooking.
Once switched off, the energy consumption in kWh will
be displayed for 10 seconds.
You can find out how to switch this function on in the
section on ~ "Basic settings"
42
tCookware check
T his function can be used to check the speed and
C o o k w a r e c h e c k
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
Fill the pan with approximately 200 ml water and
1.
place it at room temperature in the middle of the
hotplate that most closely matches the diameter of
the pan base.
Call up the basic settings and select the Cookware
2.
test option. Follow the instructions on the display
panel.
The function has now been activated.
After 10 seconds, information on the quality and speed
of the cooking process will appear in the hotplate
displays.
If the test result is not as good as it could be, test the
saucepan again on one of the smaller hotplates.
To repeat the test, call up the basic settings again and
select the Cookware test option.
Notes
The flexible cooking zone only counts as a single
■
hotplate; place no more than one item of cookware
on it.
If the diameter of the hotplate used is much smaller
■
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
■
section on ~ "Basic settings".
You can find information on the type, size and
■
positioning of the cookware in the sections on
~ "Induction cooking" and ~ "Flex Zone".
Advertisement
Table of Contents
