Panasonic TX-P50GT60E Service Manual page 26

9.2.15. Work instructions for the Rubber
sheet for SC-Board
1. Rubber sheets are put between the board and rear cover
for EMC requirement and heat radiation. Confirm rubber
sheets were placed at each portion when assembling as
shown in figure.
9.2.16. Remove the SS-Board
1. Disconnect the connector (SS11).
2. Disconnect the flexible cable (SS33).
3. Disconnect the flexible cables (SS52 and SS54).
4. Remove the screws (×5
Board.
All manuals and user guides at all-guides.com
, ×3
) and remove the SS-
9.2.17. Work instructions for the Rubber
sheet for SS-Board
1. Rubber sheets are put between the board and rear cover
for EMC requirement and heat radiation. Confirm rubber
sheets were placed at each portion when assembling as
shown in figure.
9.2.18. Remove the SS2-Board
1. Disconnect the flexible cable (SS57).
2. Remove the screws (×2
9.2.19. Remove the USB cable (A-WiFi)
1. Remove the screw (×1
2. Remove the USB cable (A-WiFi).
26
) and remove the SS2-Board.
).