Panasonic TX-P50GT60E Service Manual page 24

9.2.7. Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Unlock the hooks and the tapes to free the cables
2. Disconnect the connectors (P2, P6, P11 and P35).
3. Remove the screws (×5
the P-Board.
9.2.8. Remove the A-Board
1. Unlock the hooks and the tapes to free the cables.
2. Disconnect the connectors (A1, A6 and A12).
3. Disconnect the USB cable (JK8605).
4. Disconnect the flexible cables (A20, A31, A32 and A33).
5. Remove the screws (×4
6. Remove the Side shield metal and the Bottom shield
metal.
7. Remove the A-Board.
All manuals and user guides at all-guides.com
, ×1 , ×1
) and remove
).
8. Remove the screws (×5
9. Remove the Heatsinks (bottom-1, -2), the Thermal
conductive sheet and the Heat rubber.
9.2.9. Remove the Control unit assy
1. Unlock the tape to free the cables.
2. Disconnect the connector (C14).
3. Remove the claws (×2
assy.
9.2.10. Remove the Speaker SQs
1. Unlock the hooks and the tapes to free the cables.
2. Disconnect the Relay connector.
3. Remove the screws (×2
Speaker SQs (L, R).
24
).
) and remove the Control unit
each) and remove the