Baofeng UV-5G PLUS User Manual page 36

ABR - Display
6
Illumination Time
TDR - Dual Watch,
7
Dual Reception
8 BEEP - Keypad Beep
TOT- Transmission
9
Time-out-Timer
R-CTCS
10
- Receiver CTCSS
R-DCS
11
- Receiver DCS
T-CTCS
12
- Transmitter CTCSS
T-DCS
13
-Transmitter DCS
14 Scan CTCSS
15 Scan DCS
ON [0] | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10
OFF [0] | ON [1]
OFF [0] | ON [1]
OFF [0] 15[1] - 180[12] in 15 second steps
(TIMEOUT-15)/15=[n]
OFF [0] | see CTCSS Table in Appendix C
OFF [0] | see DCS Table in Appendix C
OFF [0] | see CTCSS Table in Appendix C
OFF [0] | see DCS Table in Appendix C
OFF
OFF
36
Time-out for the LCD backlight. (seconds)
Monitor [A] and [B] at the same time. The display
with the most recent activity ([A] or [B]) becomes
the selected display
Allows audible confirmation of a key press
*This feature provides a safety switch that limits
transmission time to a programmed value. This
will promote battery conservation by not
allowing you to make excessively long
transmissions, and in the event of a stuck PTT
switch it can prevent interference to other users
as well as battery depletion
Mutes the speaker of the transceiver in the
absence of a specific and continuous sub-audible
signal. If the station you are listening to does not
transmit this specific and continuous signal, you
will not hear anything.
Mutes the speaker of the transceiver in the
absence of a specific low-level digital signal. If
the station you are listening to does not transmit
this specific signal, you will not hear anything.
Transmits a specific and continuous sub audible
signal to unlock the squelch of a distant receiver
(usually a repeater).
Transmits a specific low-level digital signal to
unlock the squelch of a distant receiver (usually a
repeater).
Allows scanning of CTCSS in VFO frequency
mode. This operation is not allowed in channel
mode.
Allows scanning of DCS in VFO frequency mode.
This operation is not allowed in channel mode.