Table of Contents
Advertisement
5.2
[System Settings]
[System Clock / Timers]
Item
[Date]
[Time]
[NTP Time Synchronization]
[Time Synchronization
Interval]
[Time Server Address]
[Auto Clear]
[Auto Job Release]
[Specify Auto Print Time]
[Time Zone]
[Daylight Savings]
62
5 Device
Sets the date of the machine's system clock.
Sets time of the machine's system clock.
Retrieves time from server and adjusts the machine's time to be the
same as time of the time server (NTP: Network Time Protocol).
Sets interval (in hours) for connecting to time server.
Sets server name or IP address of time server.
Sets whether auto clear is performed when a fixed time has passed
in a state with no operation. If [On] is selected, the time is set.
Note
Even if this is set to [Off], if no operation is performed for 1 minute
while a job is suspended, auto clear may be performed and the job may
be resumed. Job operation after auto clear is set with "Paused Job
Handling". For details of paused job handling, refer to "[Other
Settings]" (P.72).
Sets the time for releasing the current job, until the next job can be
run, when an error (paper replenishing, paper jam, etc.) has
occurred.
Sets time until printing can be done after operating the touch panel
display (except [Start]).
Sets within the range - 12 hours to + 12 hours relative to GMT.
Sets daylight savings time. During the set period, time is determined
by adding 1 hour to the current time.
Description
Advertisement
Table of Contents
