Image Quality Trouble - Fujitsu ApeosPrint C4030 Reference Manual

Symptom
Condensation has formed
in the machine.
The machine does not
switch to the Power Saver
Mode.

Image Quality Trouble

Symptom
Output is too light
(faded or unclear)
156
8 Troubleshooting
On the control panel, set the Sleep Mode trigger time to more than 60
minutes, and let the machine stand with its power on for 60 minutes.
Before using the machine, make sure that no water droplets remain
inside the machine (rollers, metal parts, etc.). If condensation occurs
frequently, keep the machine power switched on by selecting
[Device] > [System Settings] > [System Clock / Timers] > [Warmer
Mode] > [On] on the Control Panel. This may remedy the
condensation.
The machine does not enter the Low Power Mode or the Sleep Mode in
the following cases to inform users on what is happening to the
machine and provide its performance.
When the user is operating the Control Panel

When a message indicating to replace any one of the consumables is

displayed
When the machine requires user operation for paper jams or open

covers
When an error occurs due to machine failure

When the machine is executing the condensation prevention

processing as the [Warmer Mode] is set to [On]
The paper is not appropriate for the machine. Confirm the paper tray
setting and load appropriate paper.
The paper is damp. Replace the paper.
Change the paper type setting and try printing again.
No toner may be left in the toner cartridge. Confirm the remaining
toner quantity, and replace the toner cartridge with a new one.
A drum cartridge or the fusing unit is damaged or has deteriorated.
Depending on its condition, the drum cartridge or fusing unit may
need replacement. Contact your local representative.
Cause/Remedy
Cause/Remedy
>