Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
Note:
Using a height-of-cut under 51 mm (2 inches)
increases the wear on the mower-deck belt. Use a
height-of-cut that is greater than 51 mm (2 inches)
whenever possible.
Figure 27
Adjusting the Flow Baffle
You can adjust the mower-discharge flow for different
types of mowing conditions. Position the cam lock
and baffle to provide the best quality of cut.
1.
Disengage the PTO, move the motion-control
levers to the N
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
To adjust the baffle, loosen the nut
4.
Adjust the baffle and nut in the slot to the desired
discharge flow and tighten the nut.
1. Slot
g030985
26
-
position, and set the
EUTRAL
LOCK
(Figure
Figure 28
2. Nut
28).
g012676