Table of Contents
Advertisement
en Disposal
Fault
The appliance is not
working.
Appliance does not
start.
The appliance will not
heat up; the
sym-
bol is lit on the dis-
play
The control ring has
fallen out of its sup-
port.
The control ring is dif-
ficult to turn.
The interior lighting is
not working.
15.2 Information on display panel
Fault
The display shows
the error message
"Exxx"
16 Disposal
16.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
Cut through the power cord.
2.
Dispose of the appliance in an environmentally
3.
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
18
Cause and troubleshooting
Malfunction
1.
Switch off the fuse in the fuse box.
Switch the fuse back on after approx. 10 seconds.
2.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the exact error
3.
message when calling.
→ "Customer Service", Page 19
Appliance door not fully closed.
Close appliance door.
▶
Demo mode is activated.
Disconnect the appliance from power supply by briefly switching off the circuit breaker in
1.
the fuse box.
Deactivate demo mode in the basic settings in the next 3 minutes.
2.
The control ring has come out.
Place the control ring in the support in the control panel.
1.
Push the control ring into the support until it engages and can be turned.
2.
There is dirt under the control ring.
The control ring can be removed.
Note: Do not remove the control ring too often, or the support may become unstable.
1.
To remove the control ring, press down on the outer edge of the control ring.
a The control ring will tilt, making it easier to grasp.
Remove the control ring from its support.
2.
Carefully clean the control ring and its support on the appliance using a cloth and soapy
3.
water.
Do not use harsh or abrasive cleaning products.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
Dry the control ring with a soft cloth.
4.
Interior lighting is defective
Call the after-sales service.
▶
→ "Customer Service", Page 19
Cause and troubleshooting
An error has occurred.
1.
If the display shows an error message, switch the appliance off and on again.
a If the display no longer shows the error message, it was a one-off problem.
If the display continues to show or repeatedly shows the error message, contact cus-
2.
tomer service and provide them with the error code.
If the display shows error message E0532, open and close the appliance door.
3.
If the display shows error message E6501, switch the appliance off and then switch it
4.
back on again after 10 minutes.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Advertisement
Table of Contents
