Table of Contents English ... 1. Before You Start 2. Hardware Installation ... Configure the Wireless Router ... 4. Using the USB port ... 9 Troubleshooting ... Version 06.19.2009...
Installed Cable or DSL Modem Note: 1. Do not install the USB Control Center, connect printer to TEW-634GRU and connect computer to the router until instructed to do so. 2. The USB Control Center must be installed on each computer in order to use your multi-function printer or USB storage device.
Page 4
Application 300Mbps Wireless N Gigabit Router with USB Port (TEW-634GRU) Workstation with 300Mbps Notebook with 300Mbps Wireless N PCI Adapter Wireless N USB Adapter (TEW-623PI) (TEW-624UB) USB Printer Internet USB Hard Drive Workstation with Gigabit PCI Adapter Cable/DSL (TEG-PCITXR) Modem...
2. If you plan on connecting a multi- function printer to the USB port on the TEW-634GRU, install the printer drivers to your computer. Then shutdown the printer and disconnect the printer from your computer.
Page 6
TEW-634GRU’s WAN port. Connect the other end of the cable to your modem. 4. Connect one end of a RJ-45 cable to one of the TEW-634GRU's LAN ports. Connect the other end of the cable to the computer's Ethernet port.
3. Configure the Wireless Router Note: It is recommended that you configure the Wireless Router from a wired computer. 1. Open your web browser, type http://192.168.10.1 in the Address bar, and then press Enter. 2. Enter the User Name and Password, and then click Log In.
Page 8
5. Enter a Password, verify the Password and then click Next. By default, the Password is admin. 6. Select your Time Zone and then click Next. 7. Click Next. Note: Do not change default settings unless it is conflicting with your existing hardware.
Page 9
Next. By default, the SSID is TRENDnet634. Note: It is recommended that you enable encryption on the wireless router. Please refer to the User Guide on the User's Guide CD-ROM for information on setting up encryption on the wireless router.
Page 10
Internet connection. Your configuration is now complete. For detailed information regarding the TEW-634GRU's configuration and advanced settings, please refer to the Troubleshooting section, User's Guide CD-ROM, or TRENDnet's website at http://www.trendnet.com. To ensure the highest level of customer service and support, please take a moment to...
4. Using the USB port Install the Utility Note: Before installing the utility, Then shutdown the printer and disconnect the printer from your computer. Please refer to your printer's manual for printer installation instructions. 1. Insert the Utility CD-ROM into your computer's CD-ROM Drive.
Page 12
Note: Only one user can print at a time in Auto Connect mode. Once a user has finished printing, another user can print to the printer. 1. Double click on the TRENDnet USB Control Center icon. 2. Select the printer. Click AutoConnect Printer and click Set AutoConnect Printer.
Page 13
3. Select the desired printer and click Apply. 4.Click OK. 5. The USB Device Control Center will now show the printer as an AutoConnected Printer. 6. User can now start printing. 7. Select the printer. Then click Disconnect. (Optional). Note: For Auto Connect printing, a user does not have to wait for the current owner to click disconnect.
Page 14
Scanner Note: Only one user can scan at a time in Network Scanner mode. Once a user has finished scanning, another user can scan documents. 1. Select the printer. Click Network Scanner. 2. Select TWAIN or WIA and click OK. 3.
Page 15
6. Repeat steps 3, 4 and 5 to scan additional documents. Otherwise, click Close. Storage Note: Only one user can connect to the USB storage device at a time. 1. Double click on the TRENDnet USB Control Center icon. English...
Page 16
2. Click Connect. 3. Select Open folder to view files and then click OK. 4. Click Disconnect to disconnect from the storage device. English...
Troubleshooting I typed http://192.168.10.1 in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TEW- 634GRU's web configuration page? First, check your hardware settings again by following the instructions in Section 2.
Page 18
Enabled is selected for Wireless and then click Apply. Fourth, power cycle the TEW-634GRU. Unplug the power to the TEW-634GRU. Wait 15 seconds, then plug the power back in to the TEW-634GRU. Fivth, contact the manufacturer of your wireless network adapter and make sure the wireless network adapter is...
Page 19
System -> Exit in the USB Control Center to close the program. Then double click on the TRENDnet USB Control Center icon to open up the program. Fifth, power cycle the TEW-634GRU. Unplug the power to the TEW-634GRU, wait 15 seconds, then plug the TEW-634GRU back in.
Page 21
Informations générales GPL/LGPL Ce produit TRENDnet comprend un logiciel libre écrit par des programmeurs tiers. Ces codes sont sujet à la GNU General Public License ("GPL" Licence publique générale GNU) ou à la GNU Lesser General Public License ("LGPL" Licence publique générale limitée GNU).
Page 22
General Public License) ou ao LGPL (GNU Lesser General Public License). Estes códigos são distribuídos SEM GARANTIA e estão sujeitos aos direitos autorais dos desenvolvedores. TRENDnet não presta suporte técnico a estes códigos. Os detalhes do GNU GPL e do LGPL estão no CD-ROM do produto.