Drive Belts - Ariens Sno-Thro ST724 Operator's Manual

Hide thumbs Also See for Sno-Thro ST724:
Table of Contents

Advertisement

Engine Oil Check
The engine crankcase oil should be checked daily or
every 5 hours of operation. Oil level MUST be maintained
in safe operating range on dipstick at all times or engine
damage will result (See Engine Manual).
To check, park unit on a level surface and:
1. Clean all debris away from around oil cap.
2. Remove oil cap and dipstick. Wipe oil off dipstick with
a clean cloth. Replace dipstick until cap bottoms on
tube. Remove dipstick again and observe oil level.
Oil should be at the Full (F) mark.
3. If low, add oil and bring up to the Full (F) mark.
IMPORTANT: DO NOT over fill. Oil Level must not
exceed Full (F) mark.
Engine Oil Type
SAE 5W30
SAE 30
4. Replace dipstick and cap. Clean up any spilled oil.
Engine Oil Change
Change oil after first 5 hours of operation, thereafter
change oil every 25 hours (more often if required).
NOTE: Run engine just prior to changing oil. Warm oil
will flow more freely and carry away more contamination.
1. Drain crankcase by removing oil drain plug (see
Engine Manual).
2. When oil has drained replace plug and refill engine
crankcase with new oil of proper grade.
3. Recheck oil level with dipstick.
A
D
TTACHMENT
RIVE
WARNING
IMPROPER ADJUSTMENT could result in death or
serious injury. IMPELLER BRAKE MUST
DISENGAGE when clutch is engaged. Brake must be
1/16" (1,6 mm) minimum from belt when disengaged.
BELT FINGERS MUST BE between 1/16 to 1/8" from
belt with attachment clutch engaged or belt grabbing
may occur causing impeller to rotate while attachment
clutch is disengaged.
For Attachment Drive Belt Replacement:
1. Shut off engine and allow to cool completely.
16
Ambient Temperature
Below 32° F (0° C)
Above 32° F (0° C)
B
ELT
Ariens
932 Series Sno-Thro
®
4
5
1
1. Housing Bolt Holes
2. Belt Cover
3. Chute Crank
4. Hair Pin
Figure 7
3
4
1
2
1. Attachment Belt Idler
2. Belt Finger
3. Attachment Drive Belt
4. Traction Drive Belt
5. Traction Belt Idler
6. Engine Pulleys
7. Sheaves
Figure 8
®
7
3
6
5. Pinion and Gear
6. Chute Strap
7. Cap Screws
OS0801
6
5
7
OS0461
Orig. 6/99
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

932034

Table of Contents