Daikin FTXTM30R2V1B Operation Manual page 14

5 Operation
a
b
ON/
OFF
a Operation LED
b Timer LED
If operation ...and timer LED... ...then wireless LAN is...
LED...
blinks blinks
is off blinks in 0.5 second
interval
is off blinks in 1 second
interval
4 Press to exit the menu.
Result: The display will return to the default screen.
To connect the wireless LAN to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button (Wi-Fi Protected Setup) on the router (if present),
▪ The SSID (Service Set Identifier) and the KEY (password) -
located on the unit.
To connect using the WPS button
1 On home screen menu, hold
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
repeatedly.
(5 sec.)
3 Press to confirm the selection.
Result: is blinking. The timer LED is blinking in 0.5 s interval
and the operation LED is off.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
Result: If the connection to your communication device is
successful, the timer LED is blinking in 1.0 s interval and the
operation LED is off.
INFORMATION
If the connection with your router is not possible, try
procedure "To connect
number" [ 4 14].
5 Press to exit the menu.
Result: The display will return to the default screen.
Operation manual
14
not connected
running and ready to connect
to the home network via WPS
button on the router.
▪ connected to the home
network via SSID + KEY.
or
▪ connected to the home
network via WPS button on
the router.
for at least 5 seconds while
by pressing once or
1×
using SSID and KEY
To connect using SSID and KEY number
1 On home screen menu, hold
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
repeatedly.
(5 sec.)
3 Press to confirm the selection.
Result: is blinking. The timer LED and operation LED are
blinking simultaneously.
4 Open the ONECTA application on your smart device and follow
the steps on the screen.
Result: If the connection to your smart device is successful, the
timer LED is blinking in 1.0 s interval and the operation LED is
off.
5 Press to exit the menu.
Result: The display will return to the default screen.
To reset the connection setting to the factory
default
Reset the connection setting to the factory default in case you want
to:
▪ disconnect the wireless LAN and the communication device (e.g.
router) or smart device,
▪ repeat the setting if the connection was unsuccessful.
1 On home screen menu, hold
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
repeatedly.
(5 sec.)
3 Hold for at least 2 seconds to confirm the selection.
Result: is blinking. The operation and timer LEDs are blinking
at the same time in 1 s interval. The setting is reset to the
factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.
To turn off the wireless LAN connection
If you want to turn off the wireless connection function:
1 On home screen menu, press
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
repeatedly.
for at least 5 seconds while
by pressing twice or
2×
for at least 5 seconds while
by pressing twice or
2×
for at least 5 seconds while
by pressing once or
FTXTM-R, FTXTM-S
Daikin room air conditioner
3P717028-3B – 2023.03