To Attach Jumper Cables; Replacing Battery - Craftsman 917.27384 Owner's Manual

17.5 hp, 42" mower electric start automatic transmission
Table of Contents

Advertisement

TO START
ENGINE
WITH A WEAK
BATTERY
Ar_WARNING:
Lead-acid batteries gen-
erate explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection when
around batteries.
If your battery is too weak to start the
engine, it should be recharged. (See "BAT-
TERY" in the MAINTENANCE
section of
this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor is equipped
with a 12 volt system. The other vehicle
must also be a 12 volt system. Do not use
your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1. Connect one end of the RED cable
to the POSITIVE (+) terminal of each
battery(A-B),
taking care not to short
against tractor chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of
fully charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
REPLACING
BATTERY
_I_WARNING:
Do not short battery termi-
nals by allowing a wrench or any other object
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding.
1. Lift hood to raised position.
2. Remove terminal guard.
3. Disconnect
BLACK battery cable
then RED battery cable and carefully
remove battery from tractor.
4. Install new battery with terminals in
same position as old battery.
5. Reinstall terminal guard.
6. First connect RED battery cable to
positive (+) battery terminal with hex
bolt and keps nut as shown. Tighten
securely.
7. Connect BLACK grounding cable to
negative (-) battery terminal with re-
maining hex bolt and keps nut. Tighten
securely
8.
Close terminal access doors.
9.
Close hood.
Kept Nut __
_"_'
Terminal
_¢_'
"__"-_-_'_1
Access
i-""
' "
,._
Door __
Terminal_
_.
Guard /
_/_
Positive
(Red) Cable
Negative (Black)
Cable
Weak or Dead
Battery
o2o
Fully Charged
Battery
26

Advertisement

Table of Contents
loading

This manual is also suitable for:

917.273840

Table of Contents