Smeg FAB50ULCR3 Manual page 5

Table of Contents

Advertisement

• Always disconnect the appliance
from the power supply when
troubleshooting, servicing,
replacing bulbs, or cleaning.
• Have a qualified electrician
check the wall outlet and circuit to
make sure the outlet is properly
grounded.
• Qualified personnel should carry
out the installation and servicing in
compliance with existing
regulations. Service personnel
should disconnect power before
working on this appliance.
• A qualified technician must
complete the electrical
connection.
• Before any operation on the
appliance (installation,
maintenance, positioning or
movement) always wear PPE.
• Do not attempt to repair or
replace any part of this appliance
unless specifically recommended
in this manual. Any other
maintenance must be performed
by a qualified technician.
• Do not damage or drill the
coolant pipes.
• Do not damage the coolant
circuit.
• Do not use sharp instruments,
alcohol, flammable liquids, or
abrasive cleaners to remove tape
glue. Clean only with warm
water.
• WARNING: Keep ventilation
openings in the appliance
enclosure or built-in structure free
from obstructions.
• WARNING: Do not use
mechanical, electrical, or
91477A034/A
chemical products other than
those recommended by the
manufacturer to speed up the
defrosting process.
• Do not dispose of packaging
material. Separate the various
scraps by type and consign them
to the nearest separate waste
collection center.
PRECAUTION
• Before turning on the appliance
for the first time, leave it in the
upright position for at least 2
hours.
• Leave enough space around the
appliance and install it on a flat
surface.
• Do not use the open door as a
lever to move the appliance into
place.
• Do not apply excessive pressure
to the door when it is open.
• When installing the appliance be
careful not to scratch or damage
the floor.
• Do not move back and forth or
drag the appliance when trying to
move it, as you may damage the
floor.
• Never cover or block any
ventilation openings on the
appliance.
• This equipment can be used up
to a maximum height of 2000
meters/6562 feet above sea
level.
IMPORTANT SAFETY INSTRUCTIONS - 7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fab50urpb3Fab50urpg3Fab50urbl3Fab50urrd3Fab50urcrb3

Table of Contents