Table of Contents
Advertisement
Installing the coin cell battery
1.
Hold the coin cell battery with the "+" sign facing up and slide it under the securing tabs at the
positive side of the connector.
2.
Press the battery into the connector until it locks into place.
3.
Close the front bezel door.
4.
Install the:
•
bezel
•
cover
5.
Follow the procedure in
Removing the heat sink assembly
1.
Follow the procedure in
2.
Remove the:
•
cover
•
bezel
3.
Open the
front bezel
4.
To remove the heat sink assembly:
a. Disconnect the heat sink assembly cable from the connector on the system board [1].
b. Loosen the captive screws that secure the heat sink assembly to the system board [2, 3, 4, 5].
c. Lift the heat sink assembly away from the computer [6].
Installing the heat sink assembly
1.
Place the heat sink assembly on the processor.
2.
Tighten the captive screws to secure the heat sink assembly to the system board.
3.
Connect the heat sink assembly cable to the connector on the system board.
4.
Close the front bezel door.
5.
Install the:
24
After Working Inside Your
Before Working Inside Your
door.
Computer.
Computer.
Advertisement
Table of Contents
