Over-The-Air Programming (Pop 25, Astro 25, And Astro Conventional); Responding To The Notification Of Upgrade - Motorola APX 7000XE User Manual

NOTICE: The radio enables the sensor only when all the guns or tasers are placed
into the holster. A tone sounds and the radio displays Sensor On temporarily.
• If the timer expires without an event, a tone sounds, the radio switches the sensor to enabled
state, and clears the sensor status from the display.
• If the preprogrammed Sensor button or the preprogrammed Menu Select button is long-
pressed, the over-the-air (OTA) sensor notification is enabled.
2.22.16.2.2
Disabling the Sensor Permanently
Procedure:
1 Long-press the preprogrammed Sensor button or the preprogrammed Menu Select button to
permanently disable the sensors.
A tone sounds and the radio displays Sensor Off. While in this state, no events is reported
over-the-air (OTA), regardless of how many times the gun is drawn, re-inserted or weapon is
fired.
The radio generates a bad key tone if the sensor is not allowed to be disabled or there is no
sensor connected to the radio when the preprogrammed button or menu select button is
pressed.
2 Long-press the preprogrammed Sensor button or the preprogrammed Menu Select button
again to enable the OTA Sensor notification.
A tone sounds, and the radio displays Sensor On.
2.23
Over-the-Air Programming (POP 25, ASTRO 25, and ASTRO
Conventional)
This feature enables configuration data and firmware to be upgraded to your radio over-the-air. Full
use of the radio is retained during the data transfer without interrupting communication. For ASTRO 25
and ASTRO Conventional, the upgrade pauses to give priorities to voice call, and continues after the
voice call ended. For Wi-Fi, the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately or
delay changes to be installed on the radio when it is being powered up.
Your radio can also be configured to allow you to accept or reject an upgrade.
NOTICE: This feature must be preprogrammed by a qualified radio technician. Check with your
dealer or system administrator for more information.
2.23.1

Responding to the Notification of Upgrade

Procedure:
1 The display shows Upgrade? and two short, medium- pitched tones sound every 30 seconds
until the user makes a choice of either accepting, delaying, or rejecting the request.
2 Perform one of the following actions.
68012006089-FK
Advanced Features
137