Important Warning; Before First Use; First Launch - Tesla RoboStar W700 WiFi Manual

IMPORTANT WARNING!

Always charge the internal backup battery first before using the device. If the battery is not charged,
the device may not work for safety reasons. During charging, the red and blue LED flashes alternately.
When the battery is fully charged, the LED will be permanently blue.

BEFORE FIRST USE

•
ATTENTION! The device can clean glass mounted at an angle from both sides, but may not work
properly; in that case, there should be a person nearby to help in case of a problem.
•
Do not use the device on a window with glass thinner than 5 mm.
•
The device can be used on both framed and frameless windows that are larger than 50 x 70 cm.
•
If the window is too dirty, clean a small area first and place the device on it before starting
cleaning.
•
Make sure there is a gap of at least 11 cm between the glass and obstacles in the room (curtains
or furniture).
•
Please read the manufacturer's cleaning instructions before using on glass with an uneven
surface (matte, textured, glued, patterned or coated glass, tiles and tiles). The device
manufacturer is not responsible for damage caused by improper use on this sur face, the device
may not work properly.
•
Use the device only with pure distilled water to avoid limescale and clogging of the water jets.
Do not add any cleaning agents that can cause foaming, smearing or clogging of the water jets .
If the soiling condition of the window requires it, you can use a small amount of a good quality,
non-foaming, low-alcohol window cleaner to dampen the cleaning cloth or window surface.
•
Gently dampen the cleaning cloth with clean water. Turn the device upside down and attach the
cleaning cloth to it, white side down and gray cleaning side up. If you wet the cleaning cloth too
much, the device may slide, fall or not function properly when moving.
Make sure the cleaning cloth is not covering any sensor.
•
Connect the cable from the appliance to the power adapter, which then connect to the mains.
•
Install a safety wire in a suitable place, you can use a buckle to secure it, and adjust its length to
secure the device against falling. Make sure that the length of the cable or rope does not restrict
the movement of the device on the window.

FIRST LAUNCH

Connect the device to the mains and do not disconnect it from the power supply during cleaning.
Place the device on the glass in the middle of the window, at least 11 cm from its frame. Press the