Advertisement
Quick Links
To apply the GraphiTI to the
slide case of your calculator:
• With the slide case turned horizontally,
peel the back off of the GraphiTI and
position it over the rubber feet on the
slide case. When positioned correctly,
adhere the GraphiTI to the slide case
and press evenly from the center
outward so that air is not trapped. If
there are any air bubbles, press them
to the nearest edge for a smooth fit.
If necessary, you may gently remove
the GraphiTI to re-position it on the
slide case.
• To remove the GraphiTI from the slide
case, gently pull up a corner of the
GraphiTI and slowly pull it off of the
slide case. (It is recommended that
the calculator with the GraphiTI
applied not be left in high heat as this
can hinder removal of the GraphiTI.)
Remove the calculator from the slide
case when cleaning to ensure that
your calculator is not damaged. If any
adhesive residue remains on the slide
case, use a moist paper towel and
clean the slide case.
• Your GraphiTI will perform best if not
subjected to excessive hot or cold
temperatures.
GraphiTIs are provided "as-is" without warranty.
© 2005 Texas Instruments
050305
XX/IC/1L1/AW
Advertisement
