First Steps - Texas Instruments Cabri Geometry II Manual Book

First Steps

Checking system requirements
Macintosh
¦ Macintosh Classic or better.
¦ System 6.0 or later.
¦ 1 Mb available RAM for a Macintosh
Classic. (Memory requirements will be
greater for color or larger monitors than on
the Classic.)
¦ Hard disk with 1.2 Mb available for
program and demonstration files.
Windows 3.1
¦ 386 PC or better required; 486DX
recommended.
¦ PC must be in 386-Enhanced mode with
Virtual Memory enabled.
¦ VGA, SVGA video adapter and a color
monitor.
¦ 6 Mb RAM (minimum) memory installed.
¦ 7 Mb available hard disk space for program,
demonstration files, and system extensions.
¦ Mouse, or an equivalent pointing device.
Installing Cabri Geometry II
Macintosh
1. Create a folder named Cabri II on your hard
disk.
2. Insert the Cabri Geometry II Macintosh
diskette in your floppy disk drive.
3. Double-click on the Installer on the diskette
and follow the directions on the screen.
Windows 3.1
1. Insert the Cabri Geometry II for Windows
diskette #1 in your floppy disk drive.
2. From Program Manager, click on RUN and
enter A:\SETUP
prompts.
Installing Cabri Geometry II on a network
If you have purchased the network license for Cabri Geometry II, you may run the software on
your network. Use network procedures that are compatible with your network to install Cabri
Geometry II. See your Macintosh, Windows, or DOS User's manual or your network
documentation for more information, if necessary.
Note: Cabri Geometry II is supplied on high-density diskettes. If your computer will not accept
these diskettes, call, 1-800-TI-CARES and a service representative will supply you with low density
diskettes.
1-2 Chapter 1: Learning the Basics
, and then follow the screen
DOS
¦ DOS-compatible computers (PCs), 386 or
better, and running MS-DOS 3.3 or later.
¦ EGA, VGA, SVGA video adapter and a color
monitor.
¦ 3 Mb RAM (minimum) memory installed.
¦ Hard disk with 2.5 Mb available for
program and demonstration files.
¦ Mouse, or an equivalent pointing device.
Windows 95
¦ 386 PC or better required; 486DX
recommended.
¦ VGA, SVGA video adapter and a color
monitor.
¦ 6 Mb RAM (minimum) memory installed.
¦ 2 Mb available hard disk space for program
and demonstration files.
¦ Mouse, or an equivalent pointing device.
DOS
1. Insert the Cabri Geometry II DOS diskette
in your floppy disk drive.
2. At the DOS prompt, enter:
or
A:\INSTALL B:\INSTALL
follow the screen prompts.
Windows 95
1. Insert the Cabri Geometry II for Windows
diskette #1 in your floppy disk drive.
2. Click on START/RUN and enter
and then follow the screen prompts.
Copying permitted provided TI copyright notice is included
© 1997, 1999 Texas Instruments Incorporated
, and then
A:\SETUP ,