Creating A Locus - Texas Instruments TI-NSPIRE Software Manual

Creating an angle bisector by
defining three points. The second
point represents the vertex of the
angle.
Note: If you select the Pointer tool (
created angle, the angle bisector moves so that it always bisects the
angle.

Creating a locus

The Locus tool (
object with respect to another object as constrained by a shared point.
To create a locus:
1. Create a segment, line, or circle.
2. Create a point on the segment, line or circle.
3. Create another object that uses the defined point created in the
previous step.
162
) enables you to explore the range of motion of one
Point defined on the
line segment.
Circle created to use the defined
point on the segment.
Angle bisector created by
defining three points on the
page.
) and move one point of the
Using Graphs & Geometry