Graphing Routine Specifics; Graph Window Settings; Graphing In A Split Screen; Graphing Routines And System Flags - Texas Instruments TI-83 Plus Manual

88

Graphing Routine Specifics

The following section covers graph WINDOW settings, graphing in a split screen, and

graphing routines and system flags.

Graph WINDOW Settings

Fig. 2.13 below shows how the graph window is bounded by the current WINDOW
settings.
(Xmin, Ymax)
(Xmin, Ymin)
Graphing routine parameters (points) can be defined outside of the WINDOW settings.
Those settings only define what is currently viewed in the display.

Graphing in a Split Screen

If either Horizontal or Vertical (G-T) split screen is the current mode, the graphing
routines will be limited to the section of the display designated for graphing by the mode
setting.
For more information about disabling any split screen, see the Split Screen section of
this document.
Graphing Routines and System Flags
The graphing routines are grouped by common attributes into four groups. See the
System Routine Documentation for further information.
Routines that do not automatically display or redraw the current graph screen. These
routines will draw over the existing contents of the display.
TI-83 Plus Developer Guide

Fig. 2.13: Graph WINDOW Setting

Chapter 2: TI-83 Plus Specific Information
(Xmax, Ymax)
(Xmax, Ymin)
Third Release May 28, 2002