Table of Contents
Advertisement
USER GUIDE
4.
Remove door by tilting forward and lifting door off
bottom hinge. Retain shoulder washers; they will be
reused.
5.
Insert arrow clips into holes
Remove bottom hinge:
1.
Remove bottom hinge from
cabinet using a T-25 TORX
screw driver to remove three
screws.
2.
Remove corresponding screws
on opposite side of cabinet.
On some models there
may be a nut behind one
or both screws on either side.
Install bottom hinge:
Install three screws. Replace nuts if
used.
PREPARE DOOR FOR RE-INSTALLATION
Rotate gasket
1.
With a flat tool, such as a putty knife, gently pry up
beneath the gasket and spacer until it is completely
free from the door surface.
2.
Remove the rest of the
gasket, by grabbing hold
and gently pulling gasket
from gasket channel.
Door Adjustments
Gasket With Spacer
Beneath
Gasket Channel
Filler
Plunger
Bracket
3.
Remove the 3 pieces of
gasket channel filler and
set aside to be used on the
opposite end.
4.
Remove 2 screws holding
plunger bracket. Reinstall
plunger bracket in the gasket
channel on opposite corner
of door. Fasten bracket using
same 2 screws in the pre-
drilled holes.
Press down firmly
7.
Press down on middle horizontal portion of gasket until
it adheres to the door surface.
Install top hinge and door:
1.
Remove pivot screw from hinge, flip hinge over, and
install the pivot screw in the same hole from the
opposite surface.
2.
Lift the door onto the bottom
hinge.
3.
Align edge of the hinge with
the outer edge of the unit.
4.
Tighten three screws and
replace hinge cover.
5.
Replace hinge cover.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT)
19
Gasket Channel
5. Install 3 pieces of gasket
channel filler into the gasket
channel, pressing in firmly.
6. Install gasket into
channel, beginning at one
corner and pressing in
firmly.
Note: It may be
necessary to apply a
strip of two-sided tape
for a firm adhesion.
Top Hinge
Right Side
Top Hinge
Left Side
Pivot
Screw
Advertisement
Table of Contents
Troubleshooting
