Table of Contents
Advertisement
Pressure Control Knob Settings
High Pressure
Spray
To select function, align symbol on pressure control knob with setting indicator on sprayer.
Flammable materials spilled on hot, bare, motor
could cause fire or explosion. To reduce risk of burns,
fire or explosion, do not operate sprayer with cover
removed.
•
Keep all screws, nuts, washers, gaskets, and electri-
cal fittings removed during repair procedures. These
parts usually are not provided with replacement kits.
•
Test repairs after problems are corrected.
•
If sprayer does not operate properly, review repair
procedure to verify you did it correctly. See Trouble-
shooting, page 12.
•
Overspray may build up in the air passages.
Remove any overspray and residue from air pas-
sages and openings in the enclosures whenever
you service sprayer.
•
Do not operate the sprayer without the cover in
place. Replace if damaged. Covers direct cooling air
around motor to prevent overheating.
3A2361B
Low Pressure
Prime/
Rolling
Spray
Clean
To reduce risk of serious injury, including electric shock:
•
Do not touch moving or electric pars with fingers or
tools while testing repair.
•
Unplug sprayer when power is not required for test-
ing.
•
Install all covers, gaskets, screws and washers
before you operate sprayer.
• Do not run sprayer dry for more than 30 seconds.
Doing so could damage pump packings.
• Protect the internal drive parts of this sprayer from
water. Openings in the cover allow for air cooling of
the mechanical parts and electronics inside. If
water gets in these openings, the sprayer could
malfunction or be permanently damaged.
• Prevent pump corrosion and damage from freezing.
Never leave water or water-base paint in sprayer
when its not in use in cold weather. Freezing fluids
can seriously damage sprayer. Store sprayer with
Pump Armor to protect sprayer during storage.
General Repair Information
NOTICE
11
Advertisement
Table of Contents
