Table of Contents
Advertisement
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
setting, the drive belt may need to be adjusted.
31
To adjust the drive belt, first unplug the power
adapter. Then, follow the instructions below. Note: The
83
drawings show only the right side of the studio cycle.
Remove the indicated M4 x 16mm Screw (83) and the
Shield Cover (31) from each side of the studio cycle.
Next, loosen the M10 Axle Nut (27) on each side of
the studio cycle, and tighten the Adjustment Nut (26)
on each side of the studio cycle one half turn. Then,
27
firmly retighten the M10 Axle Nuts.
26
Plug in the power adapter and pedal the studio cycle
to test the adjustment. If necessary, repeat the above
actions until the pedals no longer slip.
When the drive belt is properly adjusted, reattach the
shield covers.
30
Advertisement
Table of Contents
