Cisco Nexus 9804 NX-OS Hardware Installation Manual page 80

Remove a Fabric Module
• Prepare an antistatic surface or packing materials for each module that you remove from the chassis.
Step 1 If you are replacing a fabric module, open the packaging for the new module and inspect it for damage.
If the module is damaged, alert the Technical Assistance Center (TAC) and stop this replacement process until you have
an undamaged module to install.
Step 2 Run the no poweroff module (x)location command.
a) Verify that the fabric LED for the slot that you specified turns off. Also, you can use the show platform command
to verify that the status of the module is SHUT DOWN.
Since the Fan trays are blocking the view, fabric module LEDs might not be visible. Therefore, you can verify the
fabric module LEDs status using show led location 0/FClocation command.
Step 3
Remove the fan tray covering the fabric module in the chassis.
Refer the fan tray removal
Step 4
Remove the fabric module that you are replacing by following these steps:
a) Unscrew the two captive screws on the center of each of the two handles on the fabric module (see Callout 1 in the
following figure).
b) Rotate the handles outwards until they stop (see Callout 2 in the following figure).
c) With each of the two handles in your two hands, pull the module a couple of inches (about 5 cm) out of the slot (see
the following figure).
Cisco Nexus 9804 NX-OS Mode Switch Hardware Installation Guide
74
procedure:Replace a Fan Tray, on page 71
Replace Chassis Components