Gigabyte Z490 VISION D User Manual page 74

Table of Contents

Advertisement

Recovery Volume Options
Intel
Rapid Recover Technology provides data protection by allowing users to easily restore data and system
®
operation using a designated recovery drive. With the Rapid Recovery Technology, which employs RAID 1
functionality, users can copy the data from the master drive to the recovery drive; if needed, the data on the
recovery drive can be restored back to the master drive.
Before you begin:
• The recovery drive must have equal or greater capacity than the master drive.
• A recovery volume can be created with two hard drives only. A recovery volume and a RAID array cannot
co-exist in the system at the same time, that is, if you have already created a recovery volume, you are
unable to create a RAID array.
• By default, only the master drive can be viewed in the operating system; the recovery drive is hidden.
Step 1:
Select Create RAID Volume in MAIN MENU and press <Enter> (Figure 19).
Intel(R) Rapid Storage Technology - Option ROM - 17.8.0.4460
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
RAID Volumes :
None defined.
Physical Disks :
ID
Drive Model
1
TOSHIBA DT01ACA1
2
TOSHIBA DT01ACA1
[hi]-Select
Step 2:
After entering the volume name, select Recovery under the RAID Level item and press <Enter> (Figure 20).
Intel(R) Rapid Storage Technology - Option ROM - 17.8.0.4460
[hi]-Change
Configuring a RAID Set
Copyright (C) Intel Corporation. All Rights Reserved.
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
Serial #
763ZLL4FS
763ZM7MFS
[ESC]-Exit
Figure 19
Copyright (C) Intel Corporation. All Rights Reserved.
[ CREATE VOLUME MENU ]
Name : Volume0
RAID Level :
Recovery
Disks :
Select Disks
Strip Size : N/A
Capacity : 931.5 GB
Sync : Continuous
Create Volume
[ HELP ]
Recovery: Copies data between a master and a recovery disk.
[TAB]-Next
[ESC]-Previous Menu
Figure 20
- 74 -
4. Recovery Volume Options
5. Acceleration Options
6. Exit
Size
Type/Status(Vol ID)
931.5GB
Non-RAID Disk
931.5GB
Non-RAID Disk
[ENTER]-Select Menu
[ENTER]-Select

Advertisement

Table of Contents
loading

Table of Contents