Wake-On-Lan; Wake-On-Ring; Smb; Smbus_Ps - Supermicro SUPERSERVER 6015B-NT User Manual

Wake-On-LAN

The Wake-On-LAN header is desig-
nated JWOL. See the table on the
right for pin defi nitions. You must
enable the LAN Wake-Up setting in
BIOS to use this feature. You must
also have a LAN card with a Wake-
on-LAN connector and cable.

Wake-On-Ring

The Wake-On-Ring header is desig-
nated JWOR. This function allows
your computer to receive and "wake-
up" by an incoming call to the modem
when in suspend state. See the table
on the right for pin defi nitions. You
must have a WOR card and cable to
use this feature.

SMB

The System Management Bus header
(for the PCI bus) is designated SMB.
Connect the appropriate cable here to
utilize SMB on your system. See the
table on the right for pin defi nitions.

SMBUS_PS

This header is for I 2 C, which may be
used to monitor the status of the power
supply. Due to possible noise issues,
the I 2 C cable sould be routed around
and not over top of the motherboard.
See the table on the right for pin
defi nitions.
Chapter 5: Advanced Serverboard Setup
Wake-On-LAN
Pin Defi nitions
(JWOL)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up
Wake-On-Ring
Pin Defi nitions
(JWOR)
Pin# Defi nition
1 Ground (Black)
2 Wake-up
SMB Header
Pin Defi nitions (SMB)
Pin# Defi nition
1 Data
2 Ground
3 Clock
4 No Connection
SMBUS_PS (I
Pin Defi nitions
Pin# Defi nition
1 Clock
2 SMB Data
3 N/A
4 N/A
5 N/A
5-17
2 C)